Problem
When installing a Zebra printer using the ZDesigner driver you will need to apply the following settings if you are using the standard e_card layout in EXact:
Solution
These settings will need to be applied to Printing Preferences under the General Tab and Printing Defaults under the Advanced Tab.
Both these tabs can be found by right clicking the printer driver and left clicking properties.
Chose the epl driver from the list as opposed the the normal gk420d driver if it does not print on the page.
The new drivers for zebra printers only allow input for sizes in metric. For ease of reference, based on the above screenshot, these would be equivalent to;
Width - 57.15 mm
Height - 78.74 mm
Within Exact to configure the Z Printer
LOG IN TO EXACT AS SUPER USER
PRINT DRIVER
1. Go to Configure > Printing Setup
2. Highlight the Appointment card printer and click the e/d button (under the top box to the right)
3. Select the correct print driver from the drop down
4. Click OK
SET PRINTER FOR APPOINTMENT CARDS
1. Go to configure and printing setup
2. Double click on Patient appointment list - this will bring up an edit screen
3. Next to the box that says printer click lined icon and select the card printer
4. Click OK
PRINT DRIVER
1. Go to Configure > Printing Setup
2. Highlight the Appointment card printer and click the e/d button (under the top box to the right)
3. Select the correct print driver from the drop down
4. Click OK
SET PRINTER FOR APPOINTMENT CARDS
1. Go to configure and printing setup
2. Double click on Patient appointment list - this will bring up an edit screen
3. Next to the box that says printer click lined icon and select the card printer
4. Click OK
Related articles
Filter by label
There are no items with the selected labels at this time.